Septodont Marieflex Normal Dental Alginate - 454gm

Marieflex Alginate Impression Material is a reliable and versatile solution for a wide range of dental applications. Designed for precision and ease of use, Marieflex delivers accurate impressions essential for diagnostic models, orthodontic case studies, and the fabrication of mouth guards, provisional restorations, bleaching trays, partial denture frameworks, and occlusal splint appliances.

This "Normal" setting alginate offers optimal working and setting times, adapting well to diverse clinical needs. Its dust-free formula enhances safety and handling during preparation, ensuring a cleaner working environment.

To further enhance patient experience, Marieflex features a pleasant mango flavor, promoting better compliance and comfort during impression-taking procedures.

Key Features:

• 
  

  High-precision impressions for a wide range of clinical and laboratory applications

  
  


• 
  

  Normal setting time suitable for most clinical workflows

  
  


• 
  

  Patient-friendly mango flavor

  
  


• 
  

  Dust-free formulation for improved safety and cleanliness

  
  


• 
  

  Supplied in a 454g sachet for convenient use

  
  

Preparation:

Ensure all trays and instruments are clean and dry.

Use a flexible rubber or plastic mixing bowl and a stiff spatula.

Recommended water temperature: 20–22°C (cooler water increases working time; warmer water decreases it).

Mixing:

Measure
the required amount of alginate powder and water according to the
manufacturer's recommended powder-to-water ratio (typically 2 scoops
powder to 1 measure of water; confirm on the packaging).

Add water to the bowl first, followed by the powder.

Mix vigorously for 45–60 seconds until a smooth, creamy, homogeneous consistency is achieved.

Loading the Tray:

Quickly load the alginate into the impression tray, avoiding air bubbles.

Smooth the surface with a damp gloved finger to ensure patient comfort.

Taking the Impression:

Position the tray in the patient’s mouth and gently seat it in place.

Hold the tray steadily in position until the material sets (usually around 60–90 seconds; refer to the exact setting time on the product label).

Avoid movement during setting to ensure accuracy.

Removal:

Once set, remove the impression tray with a quick, firm motion to avoid tearing.

Rinse the impression under cool running water to remove any debris or saliva.

Disinfection:

Disinfect
the impression using a suitable alginate-compatible disinfectant spray
or immersion method according to standard infection control protocols.

Do not leave the impression in disinfectant longer than recommended.

Storage:

Wrap the impression in a moist paper towel and place it in a sealed plastic bag if not pouring immediately.

Pour the cast within 15–30 minutes for best dimensional accuracy.