Preparation:
Ensure the tooth is clean and dry. Use a rubber dam if necessary to isolate the area.
Apply retraction paste and clean the tooth surface thoroughly.
Etching:
Apply a phosphoric acid etchant to the prepared cavity for 15-30 seconds.
Rinse thoroughly with water and dry the tooth without desiccating it.
Bonding:
Apply a bonding agent according to the instructions.
Light-cure the bonding agent for the recommended time.
Warming (Optional):
Warm the capsules up to 70°C for up to one hour if desired.
Dispensing:
Attach the capsule to a dispensing gun.
Application:
Dispense the flowable restorative material directly into the cavity.
Use a dental instrument to ensure even distribution and fill the entire cavity space.
Layering:
For deep cavities, apply the material in increments up to 4mm in depth.
Ensure each layer is adequately cured before applying the next layer.
Curing:
Use a curing light to polymerize the material. Follow the recommended curing time.
Ensure the light covers the entire restoration area for uniform curing.
Finishing:
Once the final layer is cured, proceed with finishing and polishing the restoration.
Final Check:
Verify the occlusion and make any necessary adjustments.
Ensure the restoration is smooth and comfortable for the patient.
